Unframed 1E1 to 1FE Interface Converter
Unframed 1E1 to 1FE Interface Converter Advantage
· Based on self -copyright IC
· Support unframed mode (2048K) set and can manage the remote device
condition, OAM management data did not take up user’s timeslot
· Have the function of E1 interface loop back check, avoid the
converter crashed because of interface loop back;
· Have indicator when the device is power-off or E1 line is broken or
lose signal;
· Can set the E1 line that not to send the LINK signal to Ethernet
interface while E1 line is broken;
· The Ethernet interface supports jumbo frames (2036 Bytes);
· Inter-set dynamic Ethernet MAC address (4,096) with local data
frame filtering
· Ethernet interface supports10M/100M, half/full duplex auto-
Negotiation and AUTO-MDIX (crossed line and straightly connected
line self-adaptable);
· Have Ethernet monitor self-reset function, the equipment will not
dead
· Can achieve the remote device setting any 5 mode of Ethernet and
can closed the AUTO-MDIX function;
Unframed 1E1 to 1FE Interface Converter Overview
This interface converter provides one unframed 2048K E1 interface
and one Ethernet interface to achieve 10/100Base-T Ethernet data
transmission on the E1 channel. It is a high performance,
self-learning Ethernet bridge. This device is the extension device
of Ethernet, using network (PDH/SDH/Microwave) that provide E1
channel to achieve local and remote Ethernet interconnecting with
serial interfaces at a lower cost. The device has inter-set loop
test function to facilitate the project launching and daily
maintenance.
Unframed 1E1 to 1FE Interface Converter Technical Indexes
Parameter | Specification |
E1 Interface |
Interface Standard | comply with protocol G.703 |
Interface Rate | n*64Kbps±50ppm |
Interface Code | HDB3 |
E1 Impedance: | 75Ω (unbalance), 120Ω (balance) |
Jitter tolerance | In accord with protocol G.742 and G.823 |
Allowed Attenuation | 0~6dBm |
Ethernet Interface (10/100M) |
Interface rate | 10/100 Mbps, half/full duplex auto-negotiation |
Interface Standard | Compatible with IEEE 802.3, IEEE 802.1Q (VLAN) |
MAC Address Capability | 4096 |
Connector | RJ45, support Auto-MDIX |
Power |
Power supply | AC90V ~ 240V；DC –48V；DC +24V |
Power consumption | ≤10W |
Dimension |
Product Size (WXDXH) | 216X140X31mm |
Simple Packaging (WXDXH) | 274X193 X84mm |
Piece weight | 1.2KG |
Working environment |
Working temperature | -10°C ~ 50°C |
Working Humidity | 5%~95 % (no condensation) |
Storage temperature | -40°C ~ 80°C |
Storage Humidity | 5%~95 % (no condensation) |
Unframed 1E1 to 1FE Interface Converter Application
